Dark Looks. Heavy Tones. Black Pedals.
The Buffered Splitter Quad takes one 1/4” mono input and splits it out to four separate 1/4” mono outputs, each with its own buffer. Perfect for connecting a guitar to multiple signal paths or for adding a buffer anywhere in your signal chain to increase the strength of the signal.
The Op Amp Boost is a no-frills boost pedal designed to give your guitar signal an extra push right where you need it. With a simple one-knob control, it’s easy to dial in anything from a subtle lift to a full-on volume jump.
Because it uses an op-amp circuit, the boost stays clear, consistent, and reliable across different setups. Drop it in front of your amp to push a clean tone into natural overdrive, stack it before dirt pedals for added crunch, or place it in your effects loop for a pure volume boost that won’t color your sound.
Whether you’re cutting through a dense mix, driving your amp harder, or just giving your solos a lift, the Op Amp Boost keeps things simple while letting your rig do the talking.
ABY is a pedal that takes your guitar signal and switches it between two separate outputs (A or B) or plays it through both outputs (Y) at the same time. Output B has a switchable Ground Lift and Isolation Transformer to help reduce hum and noise caused by ground loops.
The Buffered Splitter Pedal takes one 1/4” mono input and splits it into two separate 1/4” mono outputs, each with its own dedicated buffer.
A buffer helps maintain your tone by preserving high-end clarity and signal strength, especially when using long cable runs or large pedalboards. By preventing signal loss, it keeps your sound consistent and responsive no matter how complex your rig gets.
Use it to run your guitar into two amps at once, feed different sections of your pedalboard, or simply drop it in your chain as a reliable buffer when and where you need it.
The tre_audio Mute Pedal is the most important "non-effect" on your pedalboard. Engineered for professional touring environments, this simple but vital utility allows you to instantly kill your signal path with a single stomp.
Silent Tuning & Swaps: Cut your signal to the amp for silent instrument changes or to tune without the audience hearing a note.
Emergency Kill Switch: Instantly stop runaway feedback or ground hum during transitions.
Zero Tone Loss: Features high-quality internal components and True Bypass switching to ensure that when the pedal is off, your signal remains 100% pure.
The DI-BOX converts a single-ended Unbalanced Input to a Balanced Output using an active driver that is fully specified for high performance audio applications. Even better, this DI-Box adds +6 dB of gain to the balanced output.
Parallel ¼” input jacks allow your guitar signal to pass through the DI-Box to your amp, pedal board, etc. while the balanced XLR output takes your signal to the FoH, audio interface, or wherever you might need a balanced signal.
The Devil’s Claw Pre-Amp is the pedal version of the pre-amp used in our Devil’s Claw 300W guitar amp. It features two independent channels — Replicate and Obliterate — designed for precise tone shaping and versatile gain control.
Replicate Channel: Tight, articulate, and tuned for rhythm clarity. A Tone Bypass switch removes the EQ section for a more direct, uncolored signal.
Obliterate Channel: High-gain channel with a switch for an extra gain stage for increased saturation and sustain when you need more drive.